LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2001 >> Outback Base, Standard >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Engine Controls - Self-Diagnostics - 2.2L & 2.5L >> Diagnostic Tests >> DTC P0106: Intake Manifold Pressure Sensor Circuit Range/Performance Problem - IMPREZA 2.2L, Legacy & Outback 2.5L M/T & Outback Sport

DTC P0106: Intake Manifold Pressure Sensor Circuit Range/Performance Problem - IMPREZA 2.2L, Legacy & Outback 2.5L M/T & Outback Sport

  1. Perform basic diagnostic procedure. See BASIC DIAGNOSTIC PROCEDURE . Using scan tool, select LED operation mode. If idle switch signal LED comes on, go to next step. If idle switch signal LED does not come on, check throttle position sensor circuit. Do not diagnose DTC P0106.
  2. If DTC P0106 is only DTC set, go to next step. If DTC P0107 or P0108 exist, diagnose and repair those DTCs. Do not diagnose DTC P0106.
  3. Ensure intake manifold pressure sensor bolt is tightened securely. Tighten bolt as necessary. If bolt is tightened securely, go to next step.
  4. Ensure throttle body bolts are tightened securely. Tighten bolts as necessary. If bolts are tightened securely, replace intake manifold pressure sensor. Clear memory and perform verification procedure. See CLEARING DIAGNOSTIC TROUBLE CODES  and VERIFICATION PROCEDURE  .
scientia non olet · About LEMON Manuals