Activating Air Bag System (CR-V, Insight, Odyssey, Prelude & S2000)

Ensure ignition is OFF and both battery cables are disconnected. Wait at least 3 MINUTES. Connect 2-pin driver air bag connector. Install access panel.
Connect 2-pin passenger air bag connector. Install glove box. On CR-V, Insight, Odyssey and S2000, connect both front seat belt pretensioner 2-pin connectors to SRS main harness. Install trim panels.
Reconnect battery cables. Check SRS indicator light to ensure system is functioning properly. See SYSTEM OPERATION CHECK . Reprogram radio frequencies.

Fig 1: Disabling Passenger Air Bag (CR-V)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Fig 2: Disabling Passenger Air Bag (Prelude)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Fig 3: Disabling Passenger Air Bag (Odyssey)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Fig 4: Disabling Passenger Air Bag (S2000 Shown; Insight Is Similar)

Fig 5: Disabling Seat Belt Pretensioner (CR-V Shown; Insight & Odyssey Are Similar)

Fig 6: Disabling Seat Belt Pretensioner (S2000)