LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2001 >> Outback Base, Standard >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Front Disc Brake Rotor >> Removal

Front Disc Brake Rotor: Removal

  1. Remove the brake pad. See FRONT DISC BRAKE PADS  .
  2. Remove the support. See Fig 1 .
    NOTE: Remove support only when replacing it or the rotor. It does not need to be removed when servicing the caliper body assembly.
  3. Remove disc rotor.
    NOTE: If disc rotor seizes up within the hub, drive the disc rotor out by installing an 8 mm bolt in the 2 holes on the rotor. See Fig 2 .
  4. Clean mud and foreign particles from the caliper body assembly and support.
Fig 1: Removing Support From Housing
G00305238Courtesy of SUBARU OF AMERICA, INC.
Fig 2: Identifying 8-mm Bolt Holes & Rotor Thickness (Front Disc Rotor)
G00305256Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals