Assembly (2001 Legacy & Outback - 14" Disc)

1. Clean caliper body interior using brake fluid.
2. Apply a coat of brake fluid to the piston seal and fit piston seal in groove on caliper body.
3. Apply a coat of brake fluid to the entire inner surface of cylinder and outer surface of piston.
4. Apply a coat of NIGLUBE RX-2 (Part No. 0036060000) grease to the boot and fit the groove on ends of cylinder and piston boot onto cylinder.
5. Insert piston into cylinder. See Fig 1 .
   CAUTION: Do not force piston into cylinder.
6. Position the boot in grooves on the cylinder and piston. See Fig 2 .
7. Apply a coat of NIGLUBE RX-2 grease to the lock pin and guide pin outer surface, cylinder inner surface and boot grooves.
8. Install the lock and guide pin boot on support. See Fig 3 .

Fig 1: Inserting Piston Into Cylinder

Courtesy of SUBARU OF AMERICA, INC.

Fig 2: Positioning Boot In Grooves On Cylinder & Piston

Courtesy of SUBARU OF AMERICA, INC.

Fig 3: Installing Lock & Guide Pin Boot On Support

Courtesy of SUBARU OF AMERICA, INC.