LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2000 >> Outback Base, Standard >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> Air Conditioning Compressor Servicing >> SANDEN Scroll >> Clutch Coil & Shaft Seal >> Removal (Mazda)

Removal (Mazda)

  1. Remove compressor shaft nut while holding clutch plate with Clutch Holder (49-B061-010). Remove clutch pressure plate and shim(s). If clutch pressure plate cannot be removed by hand, use Pressure Plate Remover (49-B061-013).
  2. Remove pulley assembly snap ring. Install a 2-jaw puller to outer diameter of pulley and a 1.0" (25 mm) socket to compressor boss, and remove pulley. DO NOT engage puller on belt area. Hold puller in place and tighten screw to remove pulley. Remove clutch coil snap ring and clutch coil.
scientia non olet · About LEMON Manuals