LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2000 >> Outback Base, Standard >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> Air Conditioning Compressor Servicing >> SANDEN Scroll >> Clutch Coil & Shaft Seal >> Removal (Honda)

Removal (Honda)

  1. Remove shaft nut while holding clutch plate with Clutch Holder (J-37872). Remove pressure plate and shim(s). Remove snap ring.
  2. Using universal puller attached to outer diameter of pulley, and Driver (07947-6340300) in center of pulley, remove pulley. DO NOT engage puller on belt area. Hold puller in place and tighten screw to remove pulley. Remove screw for clutch coil lead. Remove snap ring and clutch coil.
scientia non olet · About LEMON Manuals