LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2000 >> Outback Base, Standard >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> Air Conditioning Compressor Servicing >> HARRISON (DELPHI Thermal) V7 7-Cylinder >> Clutch Coil & Bearing Assembly >> Removal

Clutch Coil & Bearing Assembly: Removal

  1. Remove compressor from vehicle. Place compressor in Holding Fixture (J-41790). Use Clutch Plate Spanner (J-33027) to hold clutch plate. Remove compressor shaft nut.
  2. Use Clutch Plate Remover/Installer (J-33013-B) to remove compressor clutch plate and hub. See Fig 1. Hold remover body and turn center screw into remover body to remove clutch plate and hub. Ensure forcing tip on remover/installer center screw is flat or end of shaft/axial plate will be damaged. Remove key from compressor shaft.
  3. Remove snap ring. Install Puller Pilot/Guide (J-33023-A) on front head. Position Pulley and Bearing Puller (J-41552) into inner circle of slots on pulley. Turn puller clockwise in slots to engage puller tangs with pulley. Tighten puller forcing screw against puller pilot/guide and remove pulley.
  4. Disconnect clutch coil lead. Scribe marks on compressor and clutch coil for installation reference. Install Puller Pilot/Guide (J-33023-A) on front head. Remove clutch coil using puller pilot/guide and 2-jaw puller. Position puller jaws under edge of clutch coil.
Fig 1: Exploded View Of Compressor (Harrison V7 7-Cyl.)
G98J04111Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals