LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2000 >> Outback Base, Standard >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> Air Conditioning Compressor Servicing >> HARRISON (DELPHI Thermal) Hd6/Ht6 6-Cylinder >> Clutch Coil & Bearing Assembly >> Removal

Clutch Coil & Bearing Assembly: Removal

  1. Remove compressor from vehicle. Place compressor in Holding Fixture (J-33026). Using Clutch Plate/Hub Remover/Installer (J-33013-B), remove compressor clutch plate and hub. See Figure.
  2. Position remover/installer center screw forcing tip flat against compressor shaft and thread remover/installer into hub. End of shaft will be damaged if forcing tip is not flat. Hold remover/installer body and turn center screw into remover/installer body and remove clutch plate and hub. Remove shaft key from compressor shaft.
  3. Remove snap ring. Install Pulley/Bearing Puller Guide (J-33023-A) on front head. Position Pulley/Bearing Puller (J-41552) into inner circle of slots on pulley. Turn puller clockwise until engaged in pulley slots. Tighten puller screw against puller guide until pulley is removed.
  4. Disconnect clutch coil connector. Scribe match marks on compressor and clutch coil connector for installation reference. Install Puller Pilot Adapter (J-33023-A) on front head of compressor. Install Puller Crossbar (J-8433-1), Puller Legs (J-33025), and Forcing Screw (J-8433-3). Tighten puller forcing screw against pilot adapter and remove clutch coil. See Figure.
scientia non olet · About LEMON Manuals