LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2000 >> Outback Base, Automatic >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> Air Conditioning Compressor Servicing >> HARRISON (DELPHI Thermal) V7 7-Cylinder >> Shaft Seal >> Removal

Shaft Seal: Removal

  1. Discharge A/C system, using approved refrigerant recovery/recycling equipment. Remove compressor from vehicle. Remove clutch plate and hub assembly. See CLUTCH COIL & BEARING ASSEMBLY . See Figure.
  2. Remove shaft seal snap ring. Ensure all surfaces around seal are clean. Insert Shaft Seal Remover/Installer (J-42136) into shaft seal. Rotate handle clockwise to seat seal remover/installer in seal. Remove shaft seal. Ensure shaft and inside of compressor neck are clean and free of foreign material. Thoroughly clean "O" ring groove in front head.
scientia non olet · About LEMON Manuals