LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2000 >> Outback Base, Automatic >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Mechanical - 2.5L SOHC 4-Cylinder >> Removal & Installation >> Water Pump >> Removal

Water Pump: Removal

  1. Disconnect negative battery cable. Raise and support vehicle. Remove under cover(s). Drain engine coolant. Disconnect radiator and heater by-pass hoses from water pump. Disconnect electrical harness connectors from electric cooling fans. Disconnect transaxle cooler hose from 2 clips under main radiator fan shroud. Lower vehicle.
  2. Disconnect overflow hose at radiator filler neck. Remove coolant reservoir tank. Remove electric cooling fans. Remove all accessory drive belts. Remove timing belt. See TIMING BELT . Remove belt tensioner adjuster and camshaft position sensor. Remove belt idler No. 3.
  3. Using Camshaft Sprocket Wrench (499207100), remove left camshaft pulley. Remove left inner (rear) timing belt cover. Remove tensioner bracket. Disconnect heater hose from water pump. Remove water pump.
scientia non olet · About LEMON Manuals