Air Bag Safety Precautions

Observe following precautions when working with air bag system:

• Disable air bag system before servicing any air bag system or steering column component. Failure to disable system could result in accidental air bag deployment and possible personal injury. See DISABLING & ACTIVATING AIR BAG SYSTEM .
• Wait at least 20 seconds after disconnecting battery cables before servicing air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM . Back-up power supply maintains air bag system power for a few seconds after battery is disconnected. Servicing air bag system before 20 seconds have elapsed may cause accidental air bag deployment and possible personal injury.
• When trouble shooting air bag system, always check for diagnostic codes before disconnecting battery.
• When working near, removing, or installing an undeployed air bag module, DO NOT position yourself directly in front of air bag.
• In a minor collision in which air bag does not deploy, front air bag impact sensors and steering wheel pad should be inspected.
• DO NOT use air bag parts from another vehicle. Replace air bag parts with new parts.
• Remove impact sensors if shocks are likely to be applied to sensors during repairs.
• DO NOT repair damaged air bag system wiring harnesses. Manufacturer recommends replacement of any defective air bag system harness with a new part.
• DO NOT disassemble or attempt to repair impact sensors or steering wheel pad.
• If impact sensors, control module, or steering wheel pad are dropped, or if there are cracks, dents, or other defects in the case or connector, replace parts with new ones.
• DO NOT expose impact sensors, control module, or steering wheel pad to temperatures greater than 194 F (90 C).
• Use a digital volt-ohmmeter with high impedance (10 megohms minimum) for trouble shooting electrical circuit. Use of an analog circuit tester may activate air bag.
• DO NOT apply tester probes directly to any air bag system harness connector terminal. Use specified test harness during circuit testing.
• Information labels are attached to air bag components. Follow all notices on labels.
• After work on air bag system is completed, verify system is functioning properly. See SYSTEM OPERATION CHECK .
• Always wear safety glasses when servicing or handling an air bag.
• DO NOT check for air bag module continuity with air bag removed from vehicle.
• When placing a live air bag on a bench or other surface, always face air bag and trim cover up, away from surface. This will reduce motion of module if it is accidentally deployed.
• After deployment, air bag surface may contain deposits of sodium hydroxide, a skin irritant. Always wear safety glasses, rubber gloves, and long sleeved shirt during cleanup. Wash hands with mild soap and water.
• When carrying a live air bag module, ensure that trim cover faces away from your body. Doing so minimizes the risk of injury in case of deployment.
• If air bag system is not fully functional for any reason, vehicle should not be driven until system is fully repaired. DO NOT remove bulbs, modules, sensors, or other components or in any way disable system from operating normally. If air bag system is not functional, park vehicle until it is repaired and functions properly.