Rear Axle Shafts: Reassembly

Slide outer boot on axle shaft. Apply 2.12-2.47 oz. (60-70 g) of grease (Molylex No. 2) to outer CV joint. Coat inner surface of boot with 0.71-1.06 oz. (20-30 g) of grease. Install boot on outer joint. Install boot clamps and tighten to specification. See BOOT CLAMP SPECIFICATIONS table.
To complete installation, reverse removal procedure. Apply 2.82-3.17 oz. (80-90 g) of grease (VU-3A702) to inside of outer race. Coat balls and inner race with grease. Coat inside of inner boot with 0.71-1.06 oz. (20-30 g) of grease. Install boot and clamps.

BOOT CLAMP SPECIFICATIONS