LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 1997 >> Legacy Outback Limited, Automatic >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Overhaul - 4-Speed >> On-Vehicle Service >> Duty Solenoid "C" & Transfer Valve Body >> Installation

Duty Solenoid "C" & Transfer Valve Body: Installation

  1. Install duty solenoid "C", transfer valve body and oil pipe with clamp. Install rear drive shaft/transfer clutch assembly. Connect duty solenoid "C" connector and install extension housing to transaxle. Install gear selector cable and cable nut. Install vehicle speed sensor No. 1.
  2. Install rear crossmember. Lower and remove jack. Install drive shaft by aligning scribe marks. Install exhaust pipe. Reconnect oxygen sensor connector and multi-connector. Install torque rod, add fluid and check fluid level.
scientia non olet · About LEMON Manuals