LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 1997 >> Legacy Outback Limited, Automatic >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> ENGINE MECHANICAL - 2.5L DOHC 4-Cylinder >> Removal & Installation >> Intake Manifold >> Removal

Intake Manifold: Removal

  1. Release fuel pressure. See FUEL PRESSURE RELEASE . Disconnect battery negative cable. Drain engine coolant. Remove air intake/upper air cleaner cover assembly. Disconnect accelerator cable. Disconnect cruise control cable (if equipped).
  2. Remove accessory drive belt cover and belts. Remove power steering pump with hoses attached and set aside. Remove generator and bracket. Disconnect PCV, EVAP and brake booster hoses. Disconnect spark plug wires. Disconnect coolant hoses from throttle body and idle air control valve.
  3. Remove EGR pipe. Remove engine wire harness connectors and bracket. Disconnect electrical connectors from coolant temperature sensor, knock sensor, camshaft/crankshaft position sensors and oil pressure switch. Disconnect fuel hoses from pipes. Remove intake manifold.
scientia non olet · About LEMON Manuals