LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 1997 >> Legacy Brighton, Automatic >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Suspension - Rear >> Removal & Installation >> Wheel Bearing >> Installation

Wheel Bearing: Installation

  1. Ensure axle housing is free of foreign particles. Use Housing Stand (927430000) and Bearing Remover (927440000) to press bearing into housing. Press in outer race while installing bearing. Install snap ring. Use Housing Stand (927430000) and Oil Seal Installer (927460000) to install oil seal.
  2. Push oil seal into housing until it touches snap ring. Invert both Housing Stand (927430000) and Oil Seal Installer (927460000). Install inner oil seal until it touches bottom. Press sub seal into place. Apply Shell Grease (6459) to oil seal lip.
  3. Install backing plate. Use Hub Stand (927080000) and Hub Installer (927450000) to press bearing into hub. To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals