LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 1995 >> SVX L, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Air Bag Restraint System) >> Testing >> Code 23 >> Air Bag Main Wiring Harness Test

Air Bag Main Wiring Harness Test

WARNING: This page is about a different car, the 1996 Subaru SVX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Unplug 12-pin Yellow connector AB6 from control unit. Plug connector AB6 into connector 8B of test harness "B2". See Figure . Connect battery cables. Turn ignition on.
  2. Measure voltage between ground and terminals No. 1, 6, 7, and 14 at connector 5B of test harness "B2". If voltage is one volt or less at any terminal, replace air bag control unit. See CONTROL UNIT  under REMOVAL & INSTALLATION. If voltage is more than one volt at any terminal, replace air bag main wiring harness.
scientia non olet · About LEMON Manuals