LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 1995 >> SVX L, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Air Bag Restraint System) >> Testing >> Code 22 >> Air Bag Main Wiring Harness Test

Air Bag Main Wiring Harness Test

WARNING: This page is about a different car, the 1996 Subaru SVX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove glove box. Unplug harness connectors AB9 and AB10. See Figure . Plug connector AB9 into test harness "C" connector 1C.
  2. Unplug connector AB6. See Figure . Plug connector AB6 into test harness "B2" connector 8B.
  3. Measure resistance between test harness "B2" connector 5B and test harness "C" connector 3C. If resistance between connector 5B terminal No. 6 and connector 3C terminal No. 4 is more than 10 ohms, replace air bag main wiring harness. If resistance between connector 5B terminal No. 7 and connector 3C terminal No. 3 is more than 10 ohms, replace air bag main wiring harness. 4)If resistance between connector 5B terminal No. 6 and connector 3C terminal No. 4 is less than 10 ohms, replace air bag control unit. See CONTROL UNIT  under REMOVAL & INSTALLATION. If resistance between connector 5B terminal No. 7 and connector 3C is less than 10 ohms, replace air bag control unit. See CONTROL UNIT  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals