LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 1995 >> SVX L, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Air Bag Restraint System) >> Testing >> Code 02 >> Air Bag Main Wiring Harness Test

Air Bag Main Wiring Harness Test

WARNING: This page is about a different car, the 1996 Subaru SVX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Unplug 12-pin Yellow connector (AB6) from control unit. Plug connector AB6 into connector 8B of test harness "B2". See Figure .
  2. Measure resistance between ground and terminals No. 1 and 14 at connector 5B of test harness "B2". If resistance is less than 200 ohms at either terminal, replace main wiring harness. If resistance is 200 ohms or more at both terminals No., go to CLOCKSPRING CIRCUIT TEST below.
scientia non olet · About LEMON Manuals