LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 1995 >> SVX L, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Air Bag Restraint System) >> Diagnosis >> Self-Diagnostic System >> Clearing Codes

Clearing Codes

WARNING: This page is about a different car, the 1996 Subaru SVX. However, it is still accessible from the selected car via links, so may be relevant.
  1. After malfunction has been corrected, check for diagnostic codes again. See ENTERING SELF-DIAGNOSTICS.
  2. Leave ignition on and diagnostic terminal connected to diagnostic terminal No. 9. Connect remaining diagnostic terminal to terminal No. 3 of diagnostic connector for at least 3 seconds while AIR BAG warning light is flashing. See Figure .
  3. Verify codes have cleared. Unplug both diagnostic terminals from diagnostic connector. Codes cannot be cleared if problem still exists.
scientia non olet · About LEMON Manuals