LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 1992 >> Legacy Sport >> Repair and Diagnosis (Single Page) >> Transmission >> Manual Trans >> Overhaul - 5MT Series >> Component Disassembly & Reassembly >> Driven Gear Shaft (4WD) >> Disassembly

Driven Gear Shaft (4WD): Disassembly

  1. Unstake and remove lock nut. Remove lock washer. Press off 5th driven gear. Remove key. Press off roller bearing and 3rd-4th driven gear. Remove key.
  2. Remove 2nd gear assembly. Press off 1st driven gear and 2nd gear bushing, gear, and hub. Replace gear and hub if necessary. DO NOT disassemble gear and hub unless necessary. If disassembly is required, mark engagement points on all components before disassembly.
scientia non olet · About LEMON Manuals