Removal (Loyale 4WD)
- Apply parking brake. Remove cotter pin and loosen hub nut. Disconnect shock absorber from inner arm. Loosen lock bolts of crossmember outer bushing.
- Raise and support vehicle. Remove rear wheels. Separate front drive shaft from hub and wire aside. Remove hub nut and brake drum assembly. Disconnect brakeline from brake hose at inner arm bracket. Remove brake assembly from trailing arm.
- Remove inner arm bushing mount-to-crossmember bolt. Remove 3 inner-to-outer arm bolts. Remove inner arm. Put inner arm in a vise.
- Straighten staked portion of inner arm housing ring nut. Using Socket (925550000), remove ring nut. Remove spindle by lightly tapping inward with a plastic hammer. Remove outer oil seal from inner arm housing. Press bearings and races from housing and spindle.