LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 1992 >> Legacy Sport >> Repair and Diagnosis (Single Page) >> Suspension >> Rear Suspension >> Suspension - Rear >> Removal & Installation >> Wheel Bearing >> Removal (Legacy 4WD & SVX)

Removal (Legacy 4WD & SVX)

  1. Lift vehicle and remove rear wheels. Remove axle nut. Remove brake caliper and rotor. Disconnect parking brake cable. Remove rear speed sensor (if vehicle is equipped with ABS). Remove bolts connecting lateral link to axle housing.
  2. Remove bolts attaching trailing arm to axle housing. Remove spring pin attaching differential spindle to axle. Remove axle shaft. Separate axle housing from strut.
    NOTE: DO NOT remove bearings unless damaged. DO NOT reuse bearings if removed.
  3. Remove backing plate. Remove oil seals and snap ring. Use Housing Stand (927430000) and Bearing Remover (927440000) to remove bearing. Remove axle housing. Use Hub Stand (927080000) and Hub Remover (927420000) to remove hub from axle housing.
scientia non olet · About LEMON Manuals