LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 1992 >> Legacy Sport >> Repair and Diagnosis (Single Page) >> Suspension >> Rear Suspension >> Suspension - Rear >> Removal & Installation >> Rear Suspension Assembly >> Removal (Loyale)

Removal (Loyale)

  1. Remove shock absorber-to-body mounting bolts. Raise and support vehicle. Remove wheel. On 4WD models, remove axle shafts. Separate axle shaft from hub and wire aside. Disconnect drive shaft from differential. Slowly pull drive shaft out of transmission. Plug hole in transmission to prevent oil spills.
  2. Support differential with floor jack. Remove 2 center differential nuts and 4 differential-to-crossmember nuts. Remove differential from vehicle.
  3. Remove all exhaust system parts interfering with access to rear suspension. Disconnect brake hoses at inner arm brackets. Support crossmember at center with floor jack. Remove crossmember-to-body bolts and slowly lower rear suspension assembly to floor.
scientia non olet · About LEMON Manuals