LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 1992 >> Legacy Sport >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Air Bag Restraint System >> Removal & Installation >> Front Impact Sensors >> Removal (SVX)

Removal (SVX)

  1. Before proceeding, follow air bag service precautions. See SERVICE PRECAUTIONS  . Disable SRS. See DISABLING & ACTIVATING AIR BAG SYSTEM  . Disconnect air bag module 3-pin Yellow connector at base of steering column. See Figure .
  2. Front impact sensors are located in left and right fenderwell areas. Note location of impact sensor wiring harness. See Figure . Remove left console trim panel.
  3. If replacing left impact sensor, disconnect 2-pin Orange connector from control unit. Remove driver seat. If replacing right impact sensor, disconnect 2-pin Blue connector from control unit. Remove passengers seat.
  4. On all models, remove lower trim panel from front door pillar. Remove trim panel from rear quarter panel. Remove seat belt cover. Remove upper and lower sill covers. Raise and support front of vehicle. Remove front wheels and mud guards. Remove impact sensor wiring harness brackets. Remove impact sensor.
scientia non olet · About LEMON Manuals