Front Impact Sensors: Installation

1. To install front impact sensor, reverse removal procedure. Ensure all SRS wiring harness connectors are fully connected. Ensure SRS wiring harnesses are routed in original locations with all harness clips and brackets properly installed.
2. After installation procedure is complete, reactivate SRS. Check AIR BAG warning light to ensure system is functioning properly. See TESTING - SYSTEM OPERATION CHECK  .

To install front impact sensor, reverse removal procedure. Ensure all SRS wiring harness connectors are fully connected. Ensure SRS wiring harnesses are routed in original locations with all harness clips and brackets properly installed. After installation procedure is complete, reactivate SRS. Check AIR BAG warning light to ensure system is functioning properly. See TESTING - SYSTEM OPERATION CHECK  .