LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 1992 >> Legacy Sport >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Air Bag Restraint System >> Diagnosis & Testing >> Test J (Code 23) >> Air Bag Main Wiring Harness Test

Air Bag Main Wiring Harness Test

  1. Disconnect 12-pin Yellow connector AB6 from control unit. Connect connector AB6 to connector 8B of Test Harness "B" (98299PA010). See Figure . Connect battery cables. Turn ignition switch to ON position.
  2. Measure voltage between ground and terminals No. 1 and 14 at connector 5B of test harness "B". If voltage is less than one volt at both terminals, go to AIR BAG MODULE CHECK. If voltage is more than one volt at either terminal, replace air bag main wiring harness.
scientia non olet · About LEMON Manuals