LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 1992 >> Legacy Sport >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Air Bag Restraint System >> Diagnosis & Testing >> Test G (Code 13) >> Air Bag Main Wiring Harness Test

Air Bag Main Wiring Harness Test

  1. Disable SRS. See DISABLING & ACTIVATING AIR BAG SYSTEM  . Remove drivers-side lower trim panel from dash. Disconnect air bag module 3-pin Yellow connector at base of steering wheel. See Figure . Disconnect 12-pin Yellow connector AB6 from control unit. Connect connector AB6 to connector 8B of Test Harness "B" (98299PA010). See Figure .
  2. Using ohmmeter, check resistance between terminals No. 1 and 14 at connector 5B of test harness "B". If resistance is less than 10 k/ohms, replace air bag main wiring harness. If resistance is more than 10 k/ohms, go to CLOCKSPRING CIRCUIT TEST.
scientia non olet · About LEMON Manuals