Air Bag Main Wiring Harness Test
- Disable SRS. See DISABLING & ACTIVATING AIR BAG SYSTEM
. Remove drivers-side lower trim panel from dash. Disconnect air bag module 3-pin Yellow connector at base of steering wheel. See Figure
. Connect disconnected Yellow connector AB8 to terminal 1C of Test Harness "C" (98299PA020). See Figure
and Fig 1
.
Courtesy of SUBARU OF AMERICA, INC.
- Disconnect 12-pin Yellow connector AB6 from control unit. Connect connector AB6 to connector 8B of Test Harness "B" (98299PA010). See Figure
. Using an ohmmeter, check resistance between terminal No. 14 at connector 5B of test harness "B" and terminal No. 2 at connector 3C of test harness "C". If resistance is more than 10 ohms, replace air bag main wiring harness.
- If resistance is less than 10 ohms, check resistance between terminal No. 1 at connector 5B of test harness "B" and terminal No. 6 at connector 3C of test harness "C". If resistance is more than 10 ohms, replace air bag main wiring harness. If resistance is less than 10 ohms, go to CLOCKSPRING CIRCUIT TEST.