LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 1992 >> Legacy Sport >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Air Bag Restraint System >> Diagnosis & Testing >> Test C (Code 2) >> Air Bag Main Wiring Harness Test

Air Bag Main Wiring Harness Test

  1. Disconnect 12-pin Yellow connector (AB6) from control unit. Connect connector AB6 to connector 8B of Test Harness "B" (98299PA010). See Figure .
  2. Using an ohmmeter, check resistance between ground and terminals No. 1 and 14 at connector 5B of test harness "B". If resistance is less than 200 ohms at either terminal, replace main wiring harness. If resistance is more than 200 ohms at both terminals, go to CLOCKSPRING CIRCUIT TEST.
scientia non olet · About LEMON Manuals