Test B (Air Bag Warning Light Stays Off): Notes
NOTE:
Before proceeding, follow air bag service precautions. See SERVICE PRECAUTIONS
. After repairs are performed, reactivate air bag system. Recheck AIR BAG warning light to ensure system is functioning correctly. See TESTING - SYSTEM OPERATION CHECK
. For SRS connector locations, see Figure
.
- Turn ignition switch to OFF position. Remove and visually inspect fuse No. 15 from instrument panel fuse block. If fuse is okay, go to BODY WIRING HARNESS TEST. If fuse is blown, replace fuse. Turn ignition switch to ON position, and recheck AIR BAG warning light.
- If AIR BAG warning light is on, system is functioning properly now but may have an intermittent problem. Go to BODY WIRING HARNESS TEST. If AIR BAG warning light is off, recheck fuse No. 15. If fuse is blown again, replace fuse and go to BODY WIRING HARNESS TEST.