AIR BAG Warning Light & Wiring Harness Test
- Turn ignition switch to OFF position. Disconnect 7-pin Yellow connector AB1 from body wiring harness connector B140 (Legacy) or B58 (SVX). Connector is located behind left kick panel. Connect connector AB1 to connector 2A of Test Harness "A" (98299PA000). See Fig 1
.
- Turn ignition switch to ON position. Connect connectors 3A and 4A of test harness "A" together. Check AIR BAG warning light. If AIR BAG warning light is off, go to next step. If AIR BAG warning light is on, check body wiring harness and repair as necessary. After repairs are completed, disconnect connectors 3A and 4A. If body wiring harness is okay, replace AIR BAG warning light assembly. See Fig 2
. After repair is completed, disconnect connectors 3A and 4A.
- Turn ignition switch to OFF position. Reconnect connectors AB1 and B140 (Legacy) or B58 (SVX). Remove driver-side lower trim panel from dash. Disconnect air bag module 3-pin Yellow connector at base of steering column. See Figure
. Disconnect 12-pin Yellow connector AB6 from control unit. Connector connector AB6 to connector 8B of Test Harness "B" (98299PA010). See Fig 3
.
- Turn ignition switch to ON position, and connect connectors 6B and 7B of test harness "B" together. Check AIR BAG warning light. If AIR BAG warning light is off, go to GROUND CIRCUIT TEST. If AIR BAG warning light is on, replace air bag main wiring harness. After repair is completed, disconnect connectors 6B and 7B.
Courtesy of SUBARU OF AMERICA, INC.
Courtesy of SUBARU OF AMERICA, INC.
Courtesy of SUBARU OF AMERICA, INC.