LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 1992 >> Legacy Sport >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 2.2L 4-CYL & 2.2L 4-CYL Turbo - VIN [6] >> Removal & Installation >> Valve Train >> Lash Adjuster

Lash Adjuster

  1. Dip valve lash adjuster in engine oil. Push check ball in using .08" (2 mm) diameter round bar. With check ball pushed in, manually move plunger up and down at one-second intervals until air bubbles disappear.
  2. After air bubbles disappear, remove bar and quickly push plunger in to ensure it is locked. If plunger does not lock properly, replace valve lash adjuster. Always leave valve lash adjuster in engine oil until it is ready for installation.
scientia non olet · About LEMON Manuals