LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 1992 >> Legacy Sport >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 2.2L 4-CYL & 2.2L 4-CYL Turbo - VIN [6] >> Removal & Installation >> Engine >> Removal

Removal & Installation: Engine: Removal

  1. Release fuel pressure. See FUEL PRESSURE RELEASE  . Drain cooling system. Disconnect battery cable, and remove battery. Disconnect upper and lower radiator and heater hoses. Remove radiator. Disconnect electrical connectors, vacuum hoses and fuel lines.
    NOTE: Discharge A/C system using approved refrigerant recovery/recycling equipment.
  2. Disconnect accelerator cable, cruise control cable (if equipped) and hill holder cable (M/T models) at clutch release fork. Remove accessory drive belts. Remove power steering pump with hoses attached. Discharge A/C system, and disconnect hoses.
  3. Remove center exhaust pipe and heat shield. Remove air cleaner case and hoses. Disconnect engine mount from front crossmember. Remove nuts attaching lower engine to transaxle. Remove timing hole cover.
  4. Disconnect drive plate from torque converter. Remove engine torque rod. Support engine using hoist. Support transaxle using floor jack. Remove bolts attaching upper side of engine to transmission. Remove engine.
scientia non olet · About LEMON Manuals