Reassembly & Installation (Loyale)
- Replace oil seals. After lubricating thoroughly with grease, press bearings onto spindle and into housing. Install spindle into housing.
- Install and tighten ring nut. Stake ring nut. Install inner trailing arm on vehicle. Install brake assembly. Tighten ring nut and brake backing plate bolts to specification. See TORQUE SPECIFICATIONS
.
- Install spindle castle nut, washer spring and center piece in correct order. See Fig 1
. Tighten nuts and bolts to specification. See TORQUE SPECIFICATIONS
. Castle nut may be tightened an additional 30 degrees to align cotter pin slots. Bleed brake system.
Courtesy of SUBARU OF AMERICA, INC.