Removal & Installation (Rear)
- Raise and support vehicle. Remove rear wheel. Remove disc brake caliper, and wire it aside. Unplug wheel speed sensor connector and remove speed sensor from hub assembly. See Figure . Mark rotor-to-hub location, and remove brake rotor. Disconnect parking brake adjuster cable.
- Remove axle shaft nut. Remove lateral link and trailing link retaining bolts. Drive out spring pin retaining inner CV joint to drive axle case. Remove drive shaft from vehicle. Remove bolts retaining strut assembly to wheel hub assembly.
- Remove wheel hub assembly. Remove hub from wheel hub assembly using press. Remove bolts retaining tone ring to hub flange. See Figure . Remove tone ring. To install, reverse removal procedure. Use new spring pin, axle shaft nut, and training link and lateral link self-locking nuts.