Rear Brake Drum: Installation

To install, reverse removal procedure. On 2WD models, tighten wheel bearing nut to 29 ft. lbs. (39 N.m). Back nut off, and then tighten nut until hub rotating starting torque, measured using a spring scale, is 3.1-4.4 lbs. (1.4-2.0 kg). On 4WD models, tighten axle nut to 108 ft. lbs. (147 N.m).

To install, reverse removal procedure. On 2WD models, tighten wheel bearing nut to 36 ft. lbs. (49 N.m). Back nut off approximately 1/8 turn until hub rotating starting torque, measured using a spring scale, is 1.87-3.20 lbs. (.85-1.45 kg). On 4WD models, tighten axle shaft nut to 145 ft. lbs. (196 N.m).