LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 1991 >> Legacy LSi, FWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Power Brake Unit >> Removal

Power Brake Unit: Removal

  1. From inside vehicle, remove brake pedal clevis pin snap pin and clevis pin. Remove power brake retaining nuts from firewall inside vehicle. Remove master cylinder. See MASTER CYLINDER under REMOVAL & INSTALLATION.
  2. Disconnect vacuum hose at power brake unit. Remove power brake unit without damaging hydraulic lines.
scientia non olet · About LEMON Manuals