LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 1989 >> XT 1.8 5 >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.8L 4-CYL & 1.8L 4-CYL Turbo - VINS [4,5,7] >> Removal & Installation >> Cylinder Head >> Installation

Cylinder Head: Installation

  1. Ensure mating surfaces are clean and dry. Install head gasket. Coat head bolt threads with oil. Tighten bolts to specification using proper sequence. See Fig 1 . See TORQUE SPECIFICATIONS  .
  2. To install remaining components, reverse removal procedure. Tighten bolts to specification.
CAUTION: After initial start-up, cylinder head bolt torque should be rechecked after reaching operating temperature. Ensure engine is COLD while retorquing head bolts.
Fig 1: Cylinder Head Bolt Tightening Sequence
G80992Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals