LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 1989 >> XT 1.8 5 >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.8L 4-CYL & 1.8L 4-CYL Turbo - VINS [4,5,7] >> Overhaul >> Crankshaft & Connecting Rod >> Installation

Crankshaft & Connecting Rod: Installation

  1. Lubricate and install bearings in connecting rod. Install connecting rod in proper cylinder location with identification mark toward the front of crankshaft with matching numbers aligned. See Fig 1 .
    CAUTION: Connecting rods must be installed so identification mark is toward the front of crankshaft. See Fig 1 .
    Fig 1: Installing Connecting Rod
    G82170Courtesy of SUBARU OF AMERICA, INC.
  2. Apply oil to connecting rod bolt threads prior to tightening nut. Check oil clearance using Plastigage method. Replace bearings to obtain correct clearance. See CRANKSHAFT MAIN & CONNECTING ROD BEARINGS table
  3. Install main bearings in cylinder block. Install crankshaft in left side of cylinder block. Using feeler gauge, measure crankshaft end play between center bearing and crankshaft.
  4. Replace bearing if clearance is not within specification. Install right side of cylinder block to check oil clearance using Plastigage method.
  5. Tighten bolts to specification. Check oil clearance. Replace bearings to obtain correct clearance. Reassemble cylinder block.
scientia non olet · About LEMON Manuals