LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 1987 >> XT GL, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.6L 4-CYL - VIN [2] & 1.8L 4-CYL - VINS [4,5] - OHV >> Removal & Installation >> Cylinder Head >> Removal

Cylinder Head: Removal

  1. Remove intake and exhaust manifolds. Remove valve covers, rocker arm shafts and push rods. See Figure .
    NOTE: Keep push rods in correct order.
  2. Loosen cylinder head bolts in reverse of tightening sequence shown. See Fig 1 . Remove cylinder heads.
Fig 1: Cylinder Head Tightening Sequence
G82165Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals