LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 1987 >> XT GL, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.6L 4-CYL - VIN [2] & 1.8L 4-CYL - VINS [4,5] - OHV >> Overhaul >> Front Crankshaft Oil Seal >> Removal and Installation

Removal and Installation

  1. Remove front pulley bolt and tap pulley lightly to disengage. Carefully pry old seal from crankcase. Install new seal using Installer (499067000).
  2. Install crankshaft pulley. Apply oil to pulley bolt threads and liquid gasket (Three Bond 1215) on the flange seat. Prevent flywheel or flex plate from rotating and tighten to specification.
scientia non olet · About LEMON Manuals