Removal & Installation
- Crankshaft can be removed after crankcase has been separated. Remove pistons. Remove connecting rods. Remove crankshaft. Clean crankshaft and using dye penetrant, inspect for cracks.
- Measure crankshaft runout. Correct or replace crankshaft if runout exceeds specification. Measure for journal wear. See CRANKSHAFT & JOURNAL WEAR
table.
CRANKSHAFT & JOURNAL WEAR
| Application |
In. (mm) |
| Grinding Limit |
.0098 (.250) |
| Out-of-Round |
.0012 (.030) |
| Runout Limit |
.0014 (.035) |
| Taper Limit |
.0028 (.070) |