LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 1987 >> XT GL, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.6L 4-CYL - VIN [2] & 1.8L 4-CYL - VINS [4,5] - OHV >> Engine Oiling System >> Water Pump >> Installation

Water Pump: Installation

Install water pump with new gasket and sealant. Install drive belt and hoses. Gradually tighten bolts alternately and evenly in several steps to prevent leakage. The clamps for the lower radiator hose should be positioned properly to prevent interference with drive belts. Pressure test cooling system at 23 psi (1.6kg/cm2 ) and check for leaks.

NOTE: For further information on cooling systems, see appropriate article in the ENGINE COOLING section.
scientia non olet · About LEMON Manuals