LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 1987 >> XT GL, Standard >> Repair and Diagnosis (Single Page) >> Suspension >> Front Suspension >> Suspension - Front >> Removal & Installation >> Knuckle Housing & Wheel Bearing >> Installation

Knuckle Housing & Wheel Bearing: Installation

  1. Press in bearings and oil seals. Be sure to install spacer between bearings. Always use new bearings and seals. Do not mix the inner and outer seals.
  2. To install knuckle housing, reverse removal procedure. Ensure end surface of hub and disc assembly contacts ball bearings on axle shaft when installing. Ensure concave side of washer spring faces inward. Adjust wheel bearing
scientia non olet · About LEMON Manuals