LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 1987 >> XT GL, Standard >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Differentials & Drive Axles >> Drive Axle - 4WD Rear >> Removal & Installation >> Pinion Flange & Oil Seal >> Removal

Pinion Flange & Oil Seal: Removal

  1. Drain gear oil from differential. Raise and support rear of vehicle. Disconnect drive shaft from pinion flange. Measure and record rotating torque of pinion flange.
  2. Hold pinion flange with Flange Wrench (398427700 ). Remove pinion nut. Remove pinion flange with puller. Remove oil seal using Seal Puller (398527700 ).
scientia non olet · About LEMON Manuals