LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 1985 >> XT GL >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.6L 4-CYL - VIN [2] & 1.8 4-CYL - VINS [4,5] >> Removal & Installation >> Front Crankshaft Oil Seal

Front Crankshaft Oil Seal

  1. Remove front pulley bolt and tap pulley lightly to disengage. Carefully pry old seal from crankcase being sure not to damage crankcase or crankshaft surfaces.
  2. Install new seal using Installer (499067000). Install crank pulley. Apply oil to pulley bolt threads and liquid gasket (Three Bond 1215) on the flange seat. Tighten to specifications.
scientia non olet · About LEMON Manuals