Rear Suspension Assembly: Installation
To install, reverse removal procedure and note the following: Tighten outer bushing lock bolts with vehicle on ground. Bleed brake system and check rear wheel alignment.
TIGHTENING SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| Crossmember-to-Body Bolts | 87-108 (118-146) |
| Differential Mounting Nuts (4-WD) | 51-58 (69-79) |
| Inner Arm-to-Crossmember Bolts | 54-69 (73-94) |
| Outer Bushing Lock Bolts | 23-29 (31-39) |
| Outer-to-Inner Arm Bolts | 87-101 (118-137) |
| Propeller Shaft Bolts (4-WD) | 13-18 (18-24) |