Remove/Install Washer Fluid Reservoir Of Windshield Washer System - AR82.35-P-6000SR

MODEL 453 

Shown on MODEL 453.3 

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Open maintenance flap
2	Remove screw/bolt (2)
3	Remove washer fluid reservoir (1) upwards, until the pump for the windshield washer system (M5/1) is accessible	: Ensure that washer fluid reservoir (1) is correctly seated in guide.
4	Unclip washer fluid hoses from washer fluid reservoir (1) and mark	: Do not mix up washer fluid hoses at front and rear
5	Detach washer fluid hoses from pump for windshield washer system (M5/1)	Collect washer fluid which flows out.
6	Disconnect electrical connector from pump for windshield washer system (M5/1)	: When replacing the washer fluid reservoir (1) convert the pump for the windshield washer system (M5/1). Check gasket, replace if necessary.
7	Remove washer fluid reservoir (1) upwards
8	Install in the reverse order
	Check
9	Windshield washer system - inspect fluid level, adjust to correct level
10	Carry out leak check on washer fluid reservoir (1)
11	Perform function check of windshield washer system