Remove/Install Wiper Motor - AR82.30-P-6800SR
MODEL 453
| Injury hazard from pinching and crushing, in extreme cases extremities can even be cut off when caught in windshield wiper mechanism. | When working on the windshield wiper mechanism, always switch off the ignition and store transmitter key outside of transmission range (at least 2 m). | AS82.30-Z-0001-01A | |
| Remove/install | |||
| 1 | Allow wiper motor to run in end position, switch off ignition and remove key from ignition lock | ||
| 2 | Open maintenance flap | ||
| 3 | Unhook wiper linkage (2) with suitable tool | Do not bend or twist wiper linkage (2). Damage can otherwise occur. |
|
| 4 | Remove screws/bolts (4) from the windshield wiper system (5) | ||
| 5 | Disconnect electrical connector (3) from wiper motor (M6/1) | ||
| 6 | Unscrew nut (1) | *BA82.30-P-1002-01SR | |
| 7 | Remove wiper motor (M6/1) | ||
| 8 | Install in the reverse order | ||
| Check | |||
| 9 | Perform function check of windshield washer system |
WINDSHIELD WIPER
| Number | Designation | Model 453.0 | Model 453.3 | |
|---|---|---|---|---|
| BA82.30-P-1002-01SR | Screw/bolt/nut, wiper system to body | Nm | 21 | 21 |
WINDSHIELD WIPER
| Number | Designation | Model 453.4 | |
|---|---|---|---|
| BA82.30-P-1002-01SR | Screw/bolt/nut, wiper system to body | Nm | 21 |