Remove/Install Left/Right Front Axle RPM Sensor - AR42.40-P-9801SR
MODEL 453
Shown on left side of vehicle
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| Remove/install | |||
| 1 | Switch off ignition | ||
| 2 | Remove left or right front wheel and tire assembly | AR40.10-P-1100SR | |
| 3 | Remove screw/bolt (1) | *BA42.30-P-1001-01L | |
| 4 | Pull left front axle rpm sensor (L6/1) or right front axle rpm sensor (L6/2) out of steering knuckle (2) | ||
| 5 | Remove rubber grommets (4) of electrical line (3) from bracket | ||
| 6 | Remove retaining clip (6) | ||
| 7 | Pull fender liner (7) to one side in area of left front axle rpm sensor electrical connector (L6/1x1) or right front axle rpm sensor electrical connector (L6/2x1) | ||
| 8 | Disconnect left front axle rpm sensor electrical connector (L6/1x1) or right front axle rpm sensor electrical connector (L6/2x1) | ||
| 9 | Unclip electrical connector (8) from bracket (5) and remove left front axle rpm sensor (L6/1) or right front axle rpm sensor (L6/2) | ||
| 10 | Install in the reverse order | ||
| 11 |
Connect diagnostic system, read out fault memory and erase if necessary | AD00.00-P-2000-06SR |
FRONT AXLE RPM SENSOR
| Number | Designation | MODEL 453 | |
|---|---|---|---|
| BA42.30-P-1001-01L | Bolt, rpm sensor on front axle to steering knuckle | Nm | 8 |